Tuesday, February 14, 2012

Happy Birthday Framelit Card


Today's card was made using Stampin' Up!'s new Labels Framelit die set. I started out using the largest label and a piece of Poppy Parade card stock about 10" x 5-3/4".  I used the next sized label framelit and the Sale-A-Bration Designer Series Paper Everyday Enchantment to create my layer. I add texture by running the paper through my big shot using the square lattice embossing folder, after I had trimmed it down to size using the framelit and then my scissors to cut the edge off so the top aligns.

I created the flower by using the Blossom & Fancy Flower Punches, I punched a variety of flowers using coordinating CS and some of the DSP. I then ran that through the Big Shot again using the square lattice embossing folder. I crumpled the paper up really well, aligned them the way I wanted them to look and pierced using my paper piercing tool. You definitely want to use the mat pack to protect your fingers when piercing. I attached a brad and attached to the card. I used the curly label punch to create a spot for my greeting, using the Happy Birthday from the Sale-A-Bration set Elementary Elegance. I sponged around the little label using Basic Black ink. 

For the inside I added a layer of Very Vanilla Card Stock also cut as the layer on the front of the card. You can an additional birthday wish here and you could also sponge the edges for added dimension.

Well, that is all for today.
I hope you all enjoy!
DanicaA


Project Recipe: Poppy Parade, Pool Party, Calypso Coral & Very Vanilla Card Stock, Everyday Enchantment Designer Series Paper, Elementary Elegance Stamp Set, Basic Black Classic Stamp Pad, Big Shot, Labels Framelits, Square Lattice Embossing Folder, Curly Label, Blossom & Fancy Flower Punches, Everyday Enchantment Brad

No comments:

Post a Comment